Determining the wax content of crude oils by using differential scanning calorimetry

By the use of differential scanning calorimetry (DSC), a new method to measure the wax content of crude oil has been developed. In this paper, the wax content of a crude oil is proposed and proved to be the Q (total thermal effect of wax precipitation in sample) ratio of the crude oil and its corresponding wax obtained by using standard acetone method, i.e. Q_oil/Q_wax. For the 14 studied crude oils with the wax content ranging from 1 to 27 wt.%, the wax contents determined by the presented method are in good agreement with those determined by standard acetone method, with an absolute average deviation of only 0.82 wt.%. This method has an advantage over reported DSC methods in which the exact dissolution or precipitation enthalpy of wax is a must. It is also found that the wax contents determined by either of the two methods show good linear relationship with the total thermal effect Q_oil, with the correlation coefficients over 0.96. According to the empirical correlations, the wax content of a crude oil can be easily determined by using the DSC total thermal effect Q_oil. In addition and more significantly, the new method can be applied to improve the accuracy in determining the amount of precipitated wax in a waxy crude oil at different temperatures.     

Ultra-fast essential oil characterization by capillary GC on a 50 microm ID column

A 5 m x 50 microm capillary column with 0.05 microm stationary phase film thickness, with a calculated efficiency of almost 20,000 plates per metre (under optimum conditions), was used for very fasthigh resolution GC analysis of lime essential oil. The total analysis time of this volatile essential oil was less than 90 s. Fast GC is shown to be appropriate for essential oil quality assurance analysis, and quantitative results of key components are comparable with those obtained by using conventional GC analysis. The fast GC analysis is approximately 33 times faster than the conventional GC method.     

原油溶胶-凝胶等温转变过程中的流变性研究

使用RS75流变仪，采用小振幅振荡剪切方法和稳态剪切方法对含蜡原油在溶胶 -凝胶等温转变过程中的流行了研究．结果表明，等温转变成的凝胶原油的结构在 很大程度上决定于预剪切速率，非牛顿含蜡原油在结构恢复过程中表现出不可逆的 触变特性．而凝胶原油在外力作用下向溶胶状态转变的过程中，要经历从线性粘弹 性变形，到非线性粘弹性变形，再到结构屈服的过程，且高剪切应力下的溶胶原油 结构与预剪切速率无关．     

柴油中正构烷烃的高温气相色谱分析

利用高温气相色谱法对柴油中正构烷烃的碳数分布及含量进行了分析。同时根据所得数据计算出正构烷烃的平均相对分子质量及平均碳原子数。试验表明，气相色谱的最佳测定条件为：柱初温60℃，柱终温330℃，升温速率6℃／min，汽化室温度350℃。分析出吐哈两种柴油中C11～C19的正构烷烃均占分析总量的75％以上，吐哈0^#与-10^#柴油正构烷烃的平均相对分子质量、平均碳原子数分别为214．57、15．18和203．34、14．38。所得数据为设计研究针对吐哈原油有效降凝剂提供了参考数据。     

原油乳状液破乳的动态法研究

The stability of different crude oil emulsions from ASP flooding production well is studied by the method of a stirred tank. The demulsifying of crude-oil emulsion by different demulsifying agents is discussed. The breakage of the crude oil emulsions from the well PO11 by the different types and concentrations of the emulsifying agents is also discussed. The breaking mechanism of the demulsifying agent is described microscopically.     

Direct analysis of alkylnaphthalenes in crude oils by two-dimensional capillary gas chromatography

Summary Diaromatics are geochemically significant constituents of crude oils. Their determination is usually achieved by elaborate prefractionation methods, such as medium pressure liquid chromatography and HPLC, prior to capillary gas chromatography. The present contribution describes the quantitative analysis of methylnaphthalenes, ethylnaphthalenes, and dimethylnaphthalenes in selected crude oils by two-dimensional capillary GC. Since the method does not comprise any work-up procedure the determination of geochemical parameters (alkylnaphthalene concentration ratios) is performed on the original, untreated crude oil samples. Accordingly, the analytical results reflect the original composition. The influence by evaporational losses in the laboratory is minimized.     

Quantitative determination of paraffin oil in blood by capillary gas chromatography

A capillary gas chromatographic method is described for the quantitative determination of liquid paraffin in blood. Paraffin is extracted from blood into n-heptane. After solvent evaporation and dissolution of the residue in 100–200 μl n-heptane one μl is injected into a gas chromatograph fitted with a fused silica capillary column (Permabond® OV-1-CB-0.1, 10 m × 0.32 mm i.d.) and flame ionization detector. Analysis is performed by using an oven program [50°C (3 min)?285°C (5 min), rise 10%min]. The sensitivity (1.5 ng hexadecane) and the reproducibility prove the applicability of the method for the determination of liquid paraffin in blood and for the study of the stability of the liquid paraffin hollow fiber membranes used in an extracorporeal liver support system.     

Thermal behaviour and slow molecular mobility in two isomers of biphenylmethanol

This research was aimed to investigate the role of clay on the combustion and kinetic behavior of crude oils in limestone matrix. For this purpose, simultaneous TG (thermogravimetry) and DTA (differential thermal analysis) experiments were performed at three different heating rates as 10–15 and 20°C min^–1, respectively. A uniform trend of decreasing activation energies was observed with the addition of clay. It was concluded that clays surface area affects the values of Arrhenius constant, while it is the catalytic properties of clay, which lower the activation energies of all the reactions, involved in the combustion process.     

Formulation–composition map of a lecithin-based emulsion

Formulation–composition map is an interesting tool to predict the nature of an emulsion, stability, viscosity and nevertheless to decide the mixing protocol of its ingredients. Information based on optimum formulation (environmental conditions at which the affinity of an emulsifier for oil and for aqueous phase is same), which is depicted through hydrophilic–lipophilic deviation (HLD) concept, is necessary to make a formulation–composition map of an emulsion. In order to apply this concept in food emulsions, it is necessary to determine characteristic constants of each component of the system, i.e. the aqueous phase, the oil phase and the emulsifier at equilibrium. In this work formulation–composition map of a sunflower oil–water–lecithin system, based on the knowledge of phase behavior of lecithin at equilibrium and emulsification, was made. The shape of inversion line on formulation–composition map was not the classical stair type rather an almost vertical inversion line at water-fraction (f_w) near 0.20 was observed. It was supposed to be linked to the viscosity of oil phase which was 50 times the viscosity of aqueous phase. Additionally, emulsions were of oil-in-water (O/W) type for f_w higher than 0.20, but their viscosity and the drop size behavior with respect to salt concentration as formulation variable did not show the existence of transitional inversion line on formulation–composition map. Such map in advance can certainly facilitate the guidelines for dynamic emulsification.     

GC-MS法测定粮谷及油料中55种有机磷农药残留量

采用ASE-300快速溶剂萃取仪提取样品中农药残留量,提取液经二氯甲烷液-液分配、凝胶色谱柱（GPC）净化,固相萃取柱（活性炭）再净化,浓缩定容后,用气相色谱-质谱仪（GC-MS）测定,外标法定量.采用选择离子检测进行阳性确证.选择玉米、糙米、大豆、花生为实验样品、敌敌畏等55种农药添加水平在0.5～2.00 mg/kg时,该方法回收率为68%～117%;精密度为4.04%～11.76%;方法测定低限为0.005～0.100 mg/kg,各项指标均满足有关要求.